Connecting the IR Blaster
By connecting the Wireless Unit and an NOT TRANSLATEDHDMI device with the IR Blaster (supplied), you can operate the NOT TRANSLATEDHDMI device by aiming its remote control at the projector. This is useful when the projector and NOT TRANSLATEDHDMI device are placed at distant locations.
- Connect the IR Blaster to the NOT TRANSLATEDIR BLASTER connector of the Wireless Unit.
- Mount the NOT TRANSLATEDIR BLASTER head on the NOT TRANSLATEDHDMI device so that the head is aimed at the remote control receiver of the device.
To locate the remote control receiver, refer to the instruction manual supplied with the NOT TRANSLATEDHDMI device.
- Aim the NOT TRANSLATEDHDMI device’s remote control at the projector’s remote control receiver (a), then operate the remote control.
If the NOT TRANSLATEDHDMI device does not respond, change the direction of the IR Blaster.
After checking the IR Blaster works correctly, secure it with the double-sided adhesive sheet (supplied).
